BULLDOG
Diamond Member
- Jun 3, 2014
- 97,318
- 33,203
- 2,250
- Thread starter
- #301
Most people could make an auto sear in their garage with a grinder and a vice. It wouldn't be legal, but it could be done pretty easily. However, the question was other than full auto, what are the material differences between the two rifles.Well, no, it cannot be "easily" converted-the receiver is different.
That's a machined part. You think you can manufacture a machined part in your garage with a grinder and a vice? Seriously?
Of course I could. It wouldn't be nearly as pretty, but it doesn't have to be pretty to work. It just has to make contact in the right places at the right time. Doesn't take pretty to do that
Here you go dumb ass.
The M16 Trigger, Disconnector, Hammer, Selector, and Bolt Carrier are all readily available, and non regulated. It's still highly illegal to assemble them to produce a fully auto rifle, and the ATF will have a running shit fit. It can be done though.