Harbor Freight Apache 4800 as a drone case.

[Missourian]

Bought a few of these on Black Friday. I believe this is the largest of the non-rifle cases. The real trick to making these look good is don't try diagonals and remove all the blocks in the stack, then trim to the appropriate depth and replace the whole block with the part you trimmed down and the factory cut part making up the "top" which will not be the part you see at the bottom of your newly formed hole that your gun or laptop or drone is going to sit on.

In this instance, I needed a lot of diagonals...so it's not as professional looking as it could be.

But it will get the job done.

 

[1srelluc]

I have one of them on my 4-wheeler except it's black. It serves.

 

[Missourian]

I have one of them on my 4-wheeler except it's black. It serves.

The foam that fits in the lid needs some double sided tape. Might put some around the edges of the bottom foam too to keep it from pulling away where there it only one row of blocks left.

Aside from the, it is fine for the price. I think these were $27 at the time...and I've seen them on sale for close to the since then.