Warbro throttle linkage?

[Mr.Fitnah]

anyone one know how this chainsaw throttle reassembles ?

 

[Ringel05]

anyone one know how this chainsaw throttle reassembles ?

Just like the manual says it does..........

 

[Mr.Fitnah]

the z shaped link dealio?
WTF

 

[Mr.Fitnah]

anyone one know how this chainsaw throttle reassembles ?

Just like the manual says it does..........

Ahh Not clear on it

http://wem.walbro.com/distributors/servicemanuals/WTseries.pdf

 

[Mr. H.]

Prob a Youtube video onnit?

 

[Mr.Fitnah]

Ok I back on it.

 

[Mr.Fitnah]

Ok took the good parts of the craftsman the bar and chain adjuster and transfered them to the homelite that had plastic adjusting gears and made a 20 inch mayhem machine .
Somehow I managed to break by bench vise WTH is that all about?

 

[dilloduck]

anyone one know how this chainsaw throttle reassembles ?

Just like the manual says it does..........

Ahh Not clear on it

http://wem.walbro.com/distributors/servicemanuals/WTseries.pdf

Isn't that Obama's BC ?

 

[Trajan]

I got it Fitnah.....you're missing the fluke valve.

 

[Mr.Fitnah]

Seems to run fine without it. thanks

 

[blastoff]

anyone one know how this chainsaw throttle reassembles ?

Yeah, it's a snap. Just reverse the disassemble procedure. Other than that just make sure the flux capacitor is free, no gunk, etc., or replace it if it's a mess.

 

[Ernie S.]

anyone one know how this chainsaw throttle reassembles ?

Just like the manual says it does..........

Ahh Not clear on it

http://wem.walbro.com/distributors/servicemanuals/WTseries.pdf

I tend to try to remember how I take things apart. On my saws (Poulan and Husqvarna 450). you need to hook up the linkage BEFORE you slide the carb over the studs. Once the linkage is through the hole in the throttle shaft lever, pull the throttle to get enough wiggle room to mount the carb.

 

[Mr.Fitnah]

Just like the manual says it does..........

Ahh Not clear on it

http://wem.walbro.com/distributors/servicemanuals/WTseries.pdf

I tend to try to remember how I take things apart. On my saws (Poulan and Husqvarna 450). you need to hook up the linkage BEFORE you slide the carb over the studs. Once the linkage is through the hole in the throttle shaft lever, pull the throttle to get enough wiggle room to mount the carb.

Yeah me too , but sometime things just fall apart. the solution is satisfactory .
Best of both machines I can use the 16 bar or the 20 .
Im happy and more stuff is off the owrk bench.